The cables are made up of electricity conductors inside, which makes it work correctly when connected. So even if they are displayed correctly on the outside and are in good condition, you have to be careful in the way you roll it so that the drivers do not suffer any damage on the inside.
In turn, you can protect the union of the cable with the connector which is the part that suffers the most damage. You can help yourself with a spring which you must carefully wind on the charger cable in this way you will prevent it from bending and being damaged.
Find out how to wind the charger cable correctly
Initially the first thing you have to do is stretch the cable, you also have to check that it does not have any knots or kinks.
You can then grab the cable and start winding it in a circle with the help of both hands. Then you can help yourself with a rope or belt to tie the cable, remember to protect the union of the cable with the connector or plug at all times.
In turn, these methods help when you remove the cable from a charger and want to prevent it from getting lost or going around without being in a protected place.
Another method that can work is to take the cable but not from the end of the connection but from below. Always remember to be careful when joining the cable and the connector if you do not have extra protection for that area.
So by having the cable fastened in the correct way you can wind it with the help of the fingers of the hand so it will be correctly in the shape of a circle. Once you’re done, you can grab one end, pull it out a bit, and then you can start winding it up like a helicoid.
At the end you will notice that the two ends will be together and the cable will be in perfect condition so that you can store it later.
You can also do this procedure for chargers that cannot remove the cable. The cable should be grasped lower than the charger joint and the same procedure of wrapping it in a circle should be carried out. Finally with the end it can be wound in the form of a helix.
Tips to protect and keep cables organized
At the same time, there are more ways to wind a cable in this way, you will prevent them from tangling and also avoid clutter.
Initially you can grab the cable and give it an up and down movement joining without having to wind it; once you are done you can secure it with a hair tie or glue. It is a different technique, as you will not have to coil the cable and it will also protect the connections.
You can also wind the cable in the shape of a chain. So take the cable and give it about two turns in a circle then the remaining part of the cable which is stretched. You can grab it and with the help of your fingers you can pass it through the middle of the circle.
Then stretch it a little creating another circle in this way, repeat the step until the cable runs out and at the end you will obtain the chain shape. Emphasizing that this method is feasible for charger cables that are long.
Another method that can help you is to wind the cable with the spiral knot and at the end you can use the cable to turn it in the center of the spiral so you will avoid tying it with a garter or glue. Finally, pass the end through one of the spaces of the spiral that you created in this way you will get a good tie.
So there are several ideas or methods that you can implement to be able to organize and wrap the charger cables perfectly. In addition, in this way you can protect them from any damage or splitting thereof.
Finally, we hope this article has helped you. However, we would like to hear your opinion. Have you been able to wind a charger cable using these methods? Do you know of other techniques for wrapping a charger cable? Leave us your answers in the comments.